Heaters for Cross Flow Fans
These heaters for cross flow fans are available in two types. Type 1 has an open heating spiral supported by ceramic parts. Type 2 is made for use in higher airducts...
Heaters for Cross Flow Fans
These heaters for cross flow fans are available in two types. Type 1 has an open heating spiral supported by ceramic parts. Type 2 is made for use in higher airducts...
Heaters for Powerful Radial Blowers
These inoovative heaters were specially designed for the use with powerful blower units. Typical applications are professional hand and hair dryers...
Heating Crosses & Special Designs
Micanite Heating Crosses are designed for cylindric or conic air ducts and mostly used in combination with axial blowers. The spirals are often supported by internal fibre glass cords. Typical applications are hair dryers, whirlpool fans or hot air blowers...
Selection table for Flexible Heaters (up to 200°C) and Flat Heating Elements (over 200°C)
| Flexible Heaters | Flat Heating Elements | ||||
| Silicone | Kapton | Polyester | Micanite | Phlogopit | |
| Wire Wound | Etched Foil | ||||
* higher surface loads can be achieved, depending on the application, with very good heat consumption and fast control | ||||||
Continuous temperature resistance | -60 °C - 200 °C | -60 °C - 200 °C | -40 °C - 200 °C | -30 °C - 90 °C | 350 °C | 450 °C |
Continuous temperature resistance with self adhesive foil | -60 °C - 180 °C | -60 °C - 180 °C | -40 °C - 180 °C | -30 °C - 90 °C | - | - |
Short term temperature resistance | 250 °C | 200 °C | 200 °C | 100 °C | 700 °C | 900 °C |
Recommended max. watt density* | 0,8 W/cm² | 0,8 W/cm² | 0,8 W/cm² | 0,2 W/cm² | 4,0 W/cm² | 5,0 W/cm² |
Power tolerance | +5 / -10% | +5 / -10% | +5 / -10% | +/-10% | +5 / -10% | +5 / -10% |
max. dimension | 940 x 3000 mm | 595 x 2500 mm | 285 x 550 mm | 1000 x 600 mm | 2000 x 1000 mm | 2000 x 1000 mm |
min. dimension | 30 x 30 mm | 20 x 20 mm | 25 x 25 mm | 25 x 25 mm | 30 x 30 mm | 30 x 30 mm |
min. height | 1,1 - 3,0 mm | 0,8 - 1,5 mm | 0,2 mm | 0,2 mm | 2,0 mm | 2,0 mm |
Dimension tolerance | +/- 1 mm | +/- 1 mm | +/- 1 mm | +/- 1 mm | +/- 1 mm | +/- 1 mm |
Quantities | from 1 piece | from 1 piece | from 1 piece | from 25 pieces | from 1 piece | from 1 piece |
min. bend radius | 5 mm | 5 mm | 2 mm | 5 mm | - | - |
max. IP-protection | IP65 | IP65 | IP64 | IP64 | - | - |
Adhesive foil possible | yes | yes | yes | yes | no | no |
UL possible | yes | yes | no | yes | no | no |